Yeong Yang YY-5603 Mars Computer Case (cont.)
Exterior:

Click on image for larger picture
The Mars case is primarily made of steel except for the front
face which is made of plastic. Upon ordering, the Mars can be customized
to
have
a silver
face with black side vents, transparent silver face with red side
vents, or red face with silver side vents (the one in
this review).

Click on image for larger picture
The front control panel, located in the top front
corner,
features a power and reset buttons; power and HDD LEDs; two USB
ports; one Firewire port; and speaker and microphone ports.

Click on image for larger picture
Below
the control panel
is a single, exposed 3.5" drive bay covered by a red bezel.
Below that are four exposed 5.25" drive bays, each covered
with a curved bezel. Unlike other cases, these bezels are
designed to blend in perfectly with the design of the case's
face. It is a shame to have to remove them to install drives.
Needless to say, stealthing is a must. The whole red face of
the case is curved and looks like it is wrapped around the front.

Click on image for larger picture
On the left, right, and bottom sides of the red face are gray
vents. The intake fan mainly draws air from the big bottom vent
and from the lower side vents.
 
Click on image for larger picture
Removing the face
reveals a dust filter attached to the bottom half of the inside
plastic face. The one 3.5" and lower three 5.25" bays
are each covered with a steel bezel. Below the 5.25" bays
is an empty purple snap-in 120mm fan cage.

Click on image for larger picture
The top, bottom and two side panels are painted black steel. The
bottom of the computer case features rubber feet for a none-slip
grip onto the surface where the case will be placed.

Click on image for larger picture
On the right
panel
is a circular
vent
that is located off center to the top left. This is directly
over where the CPU normally is located. Also, on the right panel
is
a locking
mechanism
that secures the panel close. Sliding the key-holed button down,
causes the switch above it to pop up; thus, unlocking the case.
A pair
of keys is included to lock the mechanism so the button will
not slide down.
 
Click on image for larger picture
The back of the case features the standard assortments. A
standout feature is the huge fan vent that accommodates the 120mm
exhaust fan. The left panel is secured by two screws and the right
panel
is secured by two thumb screws.

Click on image for larger picture
|