Main Menu
|
Aspire X-Plorer Case (cont.)Interior: Inside of the case is very standard. I have seen it used in a lot of mid towers.
As mention, the back of the case supports a 120mm fan. An 80mm blue LED fan is included. Above the fan is a small lip for the power supply to rest on.
Hard drives and 5 1/4 inch drives will have to be screwed in. Each top slot has the metal punched out. The rest will have to be punched out if adding additional drives. Good thing the metal is not sharp.
Removing the front of the case shows that two intake fans can be attached. Though, these fans are 60mm fans. Taking off the front of the case takes some effort. You must unscrew four screws then pop the front off.
The other side of the case's front is a lot of wires. Here you can see that if you are not using the firewire or USB, you can unplug the cables to clean up the case. Both of these cables have individual connectors for each wire; therefore, each wire has to be plugged into the motherboard, not just a connector.
Once nice thing about this case is that the motherboard tray is removable. Unscrew a screw in the back and the tray pops right out. This makes it very easy install or upgrade your system.
A bag of screws, motherboard mounts, rubber case feet, and a speaker are included for adding all your devices to the case.
|






